Typical question / issues with AutoPIPE's Output "Analysis Summary" Sub Report

1. What sections are included in the Analysis Summary report:
   • This report section provides a summary of the current analyses. Information includes when the analysis was performed, the model revision number, and other pertinent data related to the specific analysis. The Analysis Summary include the following data:
     1. Static Analysis Settings
     2. Modal Analysis Settings
     3. Response Analysis Settings
     4. SAM Analysis Settings
     5. Code Compliance Combinations details
        • - What does D/A/P/C mean
        • -  *** NOTE ***  No operating loads analyzed.
     6. Non-Code Compliance Combinations details
     7. Code Compliance Settings
        • - What settings can affect the results
     8. Response Spectrum Load Cases Settings
     9. MSRS Group Participation Factors
     10. Interpolated Spectral Amplitudes
2. Why does the Analysis summary report not match the Data in the model? 
3. "No operating loads analyzed..." appears after the CODE COMPLIANCE settings, why? 
4. Fluid density factor

See Also

Analysis Sub-reports FAQ

Bentley AutoPIPE