Commands
- Calculation Strength command grayed out
- Analysis continuously runs
- AutoPIPE Vessel Performance – Long Analysis and Report Generation Times
Calculation
- Significantly higher values in wind loading
- Calculate bolt load for longitudinal saddle during bundle pullout
- Calculate tensile stress in bolts
- Allowable stresses input by user for test condition
- Calculation of yC: yC = m + E + m + H/2
- Calculate wall thickness for a vertical vessel; one chamber is made with 2 sections
- Longitudinal loads on saddles
- Obtaining foundation load
- Calculations for test case
- Calculate the "Period"
- Saddle support reactions are 0.00
- Reactions at bracket support
- Limpet Coil Moment of Inertia calculation verification
- Corrosion allowance consideration for anchor bolts
- Wind calculations for projected area of piping
Report
- "Show Selected Report Calculation Details", nothing seems to happen
- Execute > View Calculation Results command not working
- Rounding Error - value of pi
- Results are different when using different versions of AutoPIPE Vessel
-
Shell and Tube Heat Exchanger Volume Calculation in AutoPIPE Vessel
Modeling
- Model rectangular vessel attachment or wear plate
- Model a head with a skirt smaller than the diameter of the head
- Model Saddle on transition element like Cone
- Input elevation in the dialog of the bracket or ring
- Model nozzle loads (weights) added to the nozzles for the hydrotest case