| Applies To | |||
| Product(s): | STAAD.Pro | ||
| Version(s): | All | ||
| Environment: | N/A | ||
| Area: | Analysis Solutions | ||
| Subarea: | Miscellaneous Analysis Solutions | ||
| Original Author: | Bentley Technical Support Group | ||
This page contain solutions to miscellaneous analysis related issues
- My hand calculations do not match the displacements being reported by STAAD.Pro
- Lifting Analysis
- I defined a composite deck and I am getting the following warning during analysis ***WARNING: MEMBER 1 HAS COMPOSITE PROPERTY ASSIGNED TO IT AND HENCE THE MATERIAL CONSTANTS ARE SET AS THOSE OF STEEL. CURRENT SPECIFICATION IS IGNORED EXCEPT DAMPING RATIO
- Base plate connection for a tube column
- Changing units for existing input data in STAAD.Pro
- Error "LoadLibrary failed with error 126: The specified module could not be found"
- [[** WARNING ** A SOFT MATERIAL WITH (1.0 / 1.526E+01) TIMES THE STIFFNESS OF CONCRETE ENTERED. PLEASE CHECK.]]
- [[What is the SET NL command]]
- [[***Error*** Modulus of Elasticity Missing For Element]]
- *** NOTE: CAPACITY FOR MAXIMUM # 266 LOAD CASES IS ASSIGNED FOR PLATE LOAD
- [[**ERROR** DEPENDENT NODE xx IS BEING DEFINED AS DEPENDENT TO CONTROL NODE yy WAS PREVIOUSLY A DEPENDENT TO A PRIOR CONTROL]]
- STAAD.Pro does not use the multiple processor
- [[Different design moments for angles using beta angle]]
- [[Creating vertical seismic load manually in STAAD.Pro]]
- [[Property Reduction Factor]]
- How to run analysis on the cloud and download the results
- Long Analysis Time
- Applied Selfweight is More Than Total Weight of All Structural Elements
- Error Calculating Joint Displacements
- ERRORS IN SOLVER
- Fatal Error Cannot start analysis Engine
- Run Time Solving a Structure Involving Plates Elements
- Analyzing multiple disjointed structures in one model
- *** ERROR : "DEFINE" COMMANDS FOR LOAD GENERATION SHOULD BE PROVIDED BEFORE SPECIFYING PRIMARY LOAD CASES