Applies To
Product(s):	OpenPlant Modeler
Version(s):	CONNECT Edition 10.10.00.72 (Update 10)
Environment:	Windows 10 (64-bit)
Area:	Note
Subarea:	Flow Arrow
Original Author:	Shubham Sawant, Bentley Product Advantage Group

Background

In OpenPlant Modeler, the requirement is to place a flow arrow on the pipe. Below are wiki articles explaining the steps of how to do so.

Steps to Accomplish

1. Launch OpenPlant Modeler.
   
   
2. Place a pipe & make a view wireframe as shown
   
   
   
   
3. From Piping > Generic > Note, place a Note Type as Flow Arrow. Refer to the attached image below
   
   
   
   
4. As per the message, select the component ( here pipe) to place a arrow as shown
   
   
   
   
5. Select the location where the arrow should be placed as shown
   
   
   
   The Flow arrow is placed successfully on the pipe.
   
   

SEE Also

https://bentleysystems.service-now.com/community?id=kb_article_view&sysparm_article=KB0099354