The following resources are provided as a reference by Bentley's Technical Support Group.

Frequently Asked Questions

• Why does Flex Table Slope not match graphical conduit slope
• What is the Default Height for a Node Feature Definition
• What is Inlet Catalog Structure Width and Structure Length
• Why is Allow Soft Conflict disabled
• Why do I get the pop-up message "Hydraulic Properties - Update hydraulic properties from prototype"?
• How to limit your conduit design to only certain sizes
• How to Override the Longitudinal Slope of a Node
• Drainage and Utilities - Validation Error - 100 Inlet License limit

How To's

• Video: Using Element Symbology to annotate the external diameter of some pipes
• Video: Assign a Reference Surface to a Node
• Video: Assign an Alignment to a Node
• Video: Assign/Change Elevation Reference of a Selection Set of Nodes
• Video: Modeling a Pipe Casing Tunnel for Conduits
• Video: Adding a Parametric Constraint to Trenching Template Corridors
• Video: Modeling a Duct Bank
• Video: Item Type Syntax for Nodes and Conduits
• Video: Create HEC-RAS cross sections in a .geo file
• Video: Use the Utilities Conflicts Tool for Hard Conflicts
  
• Video: Modeling Around Culvert Pipes
• Video: Import GEOPAK Drainage Data

Best Practice

• Avoid Copying a Design File with Drainage and Utility Project Data
• Potential Issue upgrading a D&U Project modeled in the FDOT Workspace to Open X 2023 Products