Why / When the application crashed:
- Running Strength calculations
- Running Strength Calculation on a tall column with trays
- While modifying lateral support above 2100 inches from ground on a vertical skirt supported column
- No specific reason or action performed
- On Start Up
- Using Bracket type selection
Messages:
- Setup failed
- HP Connection Manager Fatal Error
Intel(r) Visual Fortran run-time error messages:
- forrtl: severe (408): fort: (8): Attempt to fetch from allocatable variable THIS when it is not allocated.
- forrtl: severe (408): fort: (10): Subscript #2 of the array WR has value 107 which is greater than the upper bound of 106
- forrtl servere (408): fort: (10) Subscript #1 of the array VERTEX has value 5 which is greater than the upper bound of 4.
- forrtl servere (408): fort: (11) Subscript #1 of the array ENC has value 0
- forrtl: severe (408): fort: (11): Subscript #3 of the array TABP has value 0
- forrtl: severe (408): fort: (11): Subscript #1 of the array COMPONENTIN has value 0 which is less than the lower bound of 1
- forrtl: severe (408): fort: (11): Subscript #1 of the array DN80 has value 0 which is less than the lower bound of 1.
- forrtl: severe (408): fort: (11): Subscript #1 of the array GEOMETRY has value 0 which is less than the lower bound of 1.
See Also
Warning Messages, Unregistered Messages, Error Messages, or Application Crash issues