RAM | STAAD Forum - Does staad support the design of W8x10 D (double profile)?
BMPCreated with Sketch.BMPZIPCreated with Sketch.ZIPXLSCreated with Sketch.XLSTXTCreated with Sketch.TXTPPTCreated with Sketch.PPTPNGCreated with Sketch.PNGPDFCreated with Sketch.PDFJPGCreated with Sketch.JPGGIFCreated with Sketch.GIFDOCCreated with Sketch.DOC Error Created with Sketch.
Question

Does staad support the design of W8x10 D (double profile)?

by
Xuan Nguyen
Explorer
Created in RAM | STAAD Forum

I am updating an old warehouse and I need to strengthen the existing end rafters. I currently have an W8x10 D and I'm getting a warning stating that : WARNING: DESIGN OF SECTION FOR MEMBER #    613 IS NOT SUPPORTED. Does staad support double wide flange sections? If not what would be a work around for this? Also I'm using AISC design code.

Thanks,

X